Behringer umc22 driver para Mac6/1/2023 Any suggestions? I am a former electronic tech for the USMC so technical stuff doesn't scare me away, just not familiar with this type of setup. I play the harmonica and take lessons that require me to record my input with a jam track. Should I go with something like the Yamaha MG10XU or the Behringer Xenyx 1204USB mixers, or the Behringer UMC22HD audio interface? Is this a problem with the inexpensive phantom interface? Plug-ins are turned off, as is the compressor and eq. My recording settings are set to Automatic Level control and the input does show the USP device, I can adjust the start of the recorded audio, by cutting the leading edge of the recording, sliding the audio to the left so it matches the start of the jam track but that seems to be a lot of trouble. The audio is much improved over the internal microphone and since I am on a budget I would like to avoid going with a full recording studio setup if possible. When I try to record with the NW-700 there seems to be a bit of a delay with the recorded audio from the phantom supply interface/microphone combination. 2-Channel USB Audio Interface 16 Bit / 48 kHz 2 Inputs and 2 outputs 1 Combi jack XLR / 6.3 mm jack and 1x 6.3 mm jack MIDAS-designed microphone preamp with. When I record audio with the internal microphone the recorded audio seems to be in-time with the Jam track I am using. I am using an NW-700 Condenser microphone with phantom supply to the USB port on the rear of the Mac. I am brand new to Garage Band and have a lot to learn. NW-700 Microphone with iMac and GarageBand I am using an iMac Retina 5K Late 2015 with the 3.2G i5, 24 GB DDR3, AMD Radeon RD M390, running Mojave 10.14.5, and Garage Band 10.3.2.
0 Comments
Leave a Reply. |